Distributor 034 with 12V Electronic Ignition and Vacuum Advance. AC905005

Upgrade from points ignition with this electronic ignition distributor.

034 advance curve with centrifugal and vacuum advance.

Built in 12V electronic ignition module.

Smoother power delivery by removing the 009's infamous "flat spot" on acceleration

Cooler engine temperatures

More power, throughout the advance curve

Better fuel economy

Engine timing should be set after installation. Use a stroboscopic timing light. Timing should be set initially at 30-32° BTDC at 3,500+ RPM, vacuum hose disconnected and plugged. Maximum advance, at 3,500+ RPM, vacuum hose connected, with no load on engine (car sitting still), light throttle, should not exceed 42-44° BTDC.

Recommended use of a Bosch Blue or other hi-energy Epoxy coil (3.4 ohms primary/12k ohms secondary) with built-in resistor. An external ballast resistor may be used between power source and distributor if your coil does not feature a built-in resistor.